Too high data rate, messages are lost. Device is in Interface Mode without SD card. Here is an example that has been prepared for you. Therefor the devices require a related license. A detailed instruction is delivered with the kit. If your application has stringent timing requirements e. Style Utilization bold Blocks, surface elements, window- and dialog names of the software.
| Uploader: | Goltizil |
| Date Added: | 26 April 2011 |
| File Size: | 56.86 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 89963 |
| Price: | Free* [*Free Regsitration Required] |
Step-by-step instructions provide assistance at these points. Close the housing by applying light pressure, and then secure it with the appropriate screw fasteners. Available power supplies can be found in the accessories manual on the driver CD. This impairs accuracy of the time system. Visit our Website for: All technical information, drafts, etc.
Common time stamp clock for each channel. The logging is not stopped but the LED state will not change till the device is rebooted.
Vector News - Vector Driver Setup Windows XP/Vista/7/8
This symbol calls your attention to warnings. A list of available Piggybacks is included in the accessories manual on the driver CD: The time stamp deviations from different Vector network interfaces are calculated and synchronized to the common PC clock. Further information about the available accessories can be found in the separate accessories manual on the driver CD: Generating time stamps Each event which is sent or received by a Vector network interface has an accurate time stamp.
Click [Next] in the driver setup dialog. The initialization process starts. Then carefully pull the PC-board out of the housing. Use this setting only if the Vector network interfaces are being synchronized over the sync line or if only a single device is used.
Vector CANcaseXL User manual
Reduction of Undesired Range Shifting in an Agricultural. For information on installing transceivers please refer to section Replacing Piggybacks on page Please note that the software synchronization must be disabled see Vector Hardware Config General information Settings Software time synchronization if the hardware synchronization is used. The test procedure can be terminated with the [Stop] button.
The left window lets you access the installed Vector devices, the right window displays the details of cancasdxl selection.
It is also possible to receive and analyze Remote Frames without any cancawexl. Select the connected CAN channels of the device s to be tested.
Start the test by pressing the button [Start Test].
If no error messages occur, the operating test was successful. If the driver has been properly installed, the device can be inserted or connected to the PC with the included USB cable. Insert the replacement Piggyback.
Vector Driver Setup 8.9.0 Windows XP/Vista/7/8
This operation involves placing the housing on a table with its back side side with the bar code facing upward. Vectof further mention will be made of the power manager in this document. Close this wizard and then execute the driver setup.
If no error messages occur, the operating test was successful.
Remove the FlexRay cable if it is connected. Due to manufacturing and temperature tolerances, the hardware clocks may vary in speed, so time stamps of various Vector devices drift over time.
The time stamp deviations from different Vector network interfaces are calculated and synchronized to the common PC clock. The screws should be secure but not excessively tight.
Comments
Post a Comment